Sterilizer & autoclave repair
A sterilizer out of service stops instrument turnover, and a unit failing spore tests is a compliance problem as much as a mechanical one. Door gaskets and fill solenoids account for most cycle faults, and both are same-visit repairs when the part is on the van.
What you’re seeing
- Cycle aborts part-way through
- Steam escaping around the door
- Failed spore test or biological indicator
- Won't reach temperature or pressure
- Chamber not draining, or water in the tray
- Error codes on the display
What the visit covers
Door gasket inspection and replacement
Fill and vent solenoid testing
Heater, thermostat and pressure sensor diagnosis
Reservoir drain, clean and water-quality check
Chamber and trap cleaning
Full cycle run and verification before sign-off
Equipment seen most oftenMidmark M9 and M11, SciCan Statim and Bravo, Tuttnauer, Pelton & Crane
Our service process
Request service
Call, or send the form with what the equipment is doing.
Diagnosis
On site at your practice, worked around your patient schedule.
Repair
The problem gets fixed, with the cost agreed before work starts.
Verify
Tested under load before the visit ends, and left running.
Everything else in the operatory
Serving New Jersey
If your town isn’t listed, call anyway — it’s a small state.
Counties
Essex County · Hudson County · Bergen County · Passaic County · Union County · Middlesex County · Morris County
Request service
If an operatory is down right now, calling is faster than the form.